23A series four-sided planer is mainly used for hardwood lines, floors, wooden doors, door frames, window frames and other large cutting volume one-time four-sided molding processing.
1.Full range of products standard frequency conversion feeding system, feeding 6-36 m / min;
2.Standard short material device;
3.High precision spindle, rotational speed 6200r/min (optional higher speed);
4.Independent motor start, according to customer actual processing needs, separate opening and closing spindle (optional with different configuration of motor power);
5.Weight-resistant cutting gearbox. 6. Equipped with 3 positions emergency stop device, install open door cover power off and feed port limit high limit switch.
Wood sample of processed products
Quick liftable short material device
This mechanism enables the smooth feeding for short woods.The auxiliary feeding roller has the function of transmission,which makes the feeding more briskly.With liftable feeding roller,you can change and adjust the knife easily
Each cutter shaft is assembled and tested under air-conditioned enviroment and is supported by SKF bearing.The stable-worked shaft guarantees the surface smoothness of finished products.
Efficient dust removal,the new duct suction structure can more effectively remove wood chips.Minimizing dents on the surface of the finished product and effectively controlling noise.
Feeding frequency inverter digital display,easy to operate,energy saving,protect the machine from wearing because of mechanical transmission.
The feed port has an active feed supporting wheel,and the culinder provides top roller pressure,allowing for smooth feeding of both wet and dry materials.
|Machine parameters||Working width(mm)||25~230|
|Spindle revolution speed(r/min)||6200|
|Motor power(kw)||1st Bottom spindle||7.5kw/10HP|
|Right vertical spindle||7.5kw/10HP|
|Left vertical spindle||7.5kw/10HP|
|1st Top spindle||11kw/15HP|
|2nd Top spindle||7.5kw/10HP|
|2nd Bottom spindle||7.5kw/10HP|
|Top spindle lifting||0.37kw/0.5HP|
|Feeding beam lifting||0.75kw/1HP|
|Spindle diameter(mm)||1st Bottom spindle||φ125|
|Right vertical spindle||φ125~φ180|
|Left vertical spindle||φ125~φ180|
|1st Top spindle||φ125~φ180|
|2nd Top spindle||φ125~φ180|
|2nd Bottom spindle||φ125~φ200|
|Remar||Feeding wheel diamter(mm)||φ140|
|Dust outlet diameter(mm)||φ140|